This is a continuation of my Sony Racking Job. Click here for previous article.
http://diy-central.com/DIYRackingSonyMXPPreampsAndEQModules.aspxThings are progressing nicely. Some photos.
Finally cut the hole for the EQ section... took about 2+ hours... it's a pain doing this. And I have to be careful not to make the square holes too big because the tolerances are very tight.
Some closeup photos of the Preamp and EQ module.
And here's a picture of my 1st Sony MXP preamp (white case) and the 2nd unit I'm currently building (black case).
Next steps:
1. Drill holes for the output transformer. I'm using an output trafo that came from an MCI console.
2. Build +18-0-18 PSU with 48V phantom power... drill holes on case for PCB and toroid transformer.
3. Wire everything!